| |
Tuesday, January 6, 2009
Business
Accounting, Aerospace And Defense...
Reference
Almanacs, Archives...
Society
Activism, Advice...
|
Kids & Teens
Arts, Computers...
Games
Board Games, Card Games...
Computers
Algorithms, Artificial Intelligence...
|
Health
Addictions, Aging...
Recreation
Antiques, Audio, Autos...
Sports
Adventure Racing, Airsoft...
|
Regional
Africa, Asia, Caribbean...
News
Alternative, Analysis And Opinion...
Science
Agriculture, Astronomy...
|
Arts
Animation, Architecture...
Home
Apartment Living, Consumer Information...
Shopping
Auctions, By Region, Children...
|
|
|
|
 |
First Look: BT I-Plate |
 |
|
BT
launched
the I-Plate last week (the 'I' stands for 'Interstitial') aimed at
residential users who have a Network Termination Equipment 5 (NTE5) master
socket through which their phone calls and broadband connection travel.The claimed benefits of the device are increased throughput and more stable
broadband connections.
This relatively simple box aims to reduce interference on the line, giving a
better signal-to-noise (SNR) ratio on ADSL broadband connections.The main culprit for interference on NTE5 master sockets is the so-called
'bell' or ring wire, which causes noise on your phone lines and reduces the SNR.
Originally the bell wire allowed bells to ring on older phones, unlike new
phones which have the ring feature built-in. So the bell wire is redundant, but
having BT come round to all residential customers and excise the wire would be
expensive.The other cause of reduced SNR could be interference picked up by the main
twisted pair lines from your phone to the master socket. Radio frequency
interference from other household appliances like TVs, and having mains wires
close to your phone lines, could also be contributors.
The first thing for users to do is to 'baseline' their broadband connection
to check the current throughput, and then to determine what they should be
getting.Putting your postcode into the Exchange checker on the
Samknows
website should give you the location of your local exchange and its distance
from your home.Our nearest exchange is just under a kilometre away, and we currently get a
maximum download speed of around 13Mbit/s from our Be ADSL2+ (24Mbit/s)
connection.We got hold of an I-Plate from BT and 'installed' it on an NTE5 socket at our
Computing & IT Week Labs branch office in Tottenham.The NTE5 socket has a split faceplate and removing the two screws from the
bottom half and gently removing it brought quite a surprise. Apart from the
large amount of crud and dust residing behind the plate, there was a piece of
sheathed cable wired to a few small connectors - but attached to nothing else.
Presumably the last owner was fairly clued in and had had the bell wire
removed, or had done it themselves, although apparently it's illegal to mess
around with the NTE5 wiring yourself. Fitting an I-Plate does not require
customers to do any rewiring.What most users should see is a wire attached to the faceplate they have just
removed. This wire needs to be threaded through the gap in the I-Plate, and then
the I-Plate is screwed to where the old faceplate was, and the old faceplate
then screwed into place over the I-Plate.This should take a couple of minutes to do. We pulled off the upper half of
the faceplate just to confirm that the bell wire had indeed been removed, which
it had.Did we get a speed increase? It was hard to tell immediately, but may become
apparent in the future. Users who have a bell wire connected should see some
improvement and BT claims that 1.5Mbit/s faster connections are typical, with
some users in BT's pre-launch trial seeing a 4Mbit/s improvement.What this could mean is that, if enough users shell out £10 for an I-Plate
and do get the claimed speed increase, there could be a significant increase in
data traffic running over the network.That means more backhauled data, and consequently more cash for BT, as ISPs
may need to cough up extra for BT backhauling that data.So the I-Plate could be a win for residential customers, and a 'nice little
earner' for BT, as Minder's Arthur Daley would say.
Taken from here
|
|
 |
|
 |
|
|
|
|